SI Controls
BS8-D Time Master
The SI-Master BS8-D is an extended SI control. In addition to being able to be programmed by you like any other control, it can also be used as a Time Master, and as an Extended Time Master. A Time Master allows the quick setting of the real-time clocks in other controls. As Extended Time Master it additionally clears the backup memory of the other controls. See the downloads section below for more info.
BSF7-D
A universal orienteering control station. It can be programmed to the following modes: Clear / Check / Start / Finish or numbered control.
BSF8
The BSF8 Timing Control comes as either a "display top" (DT) unit or a "display bottom" (DB) unit. This distinction refers to the location of the LCD readout on the control - either on the top or the bottom of the unit. In general, if a control is to have a control code sticker on its top surface, the "display bottom" unit is recommended. The DB unit is available in blue or red. The DT unit is available in blue only.
BSM-7-D-RS232
Serial Port based main station Allows programming of controls, downloading of fingerstick information
BSM-7-USB
Main station with USB interface to computer. Allows programming of controls and downloading of finger-stick information See the downloads section below for a document describing the features of this control.
BSM8-D-USB
Download station with USB interface to computer. Allows programming of controls and downloading of finger-stick information. This unit does not contain an internal battery, it is powered by the USB port. It features very low power consumption, the laptop battery will not be stressed. The unit will retain all downloads even if the unit is unplugged for a while.
